Crossmember/Chassis Mounting

[oli8925]

Are these available to buy?

I'm not quite sure what to do with it. Was trying to drop the crossmember off the body, and thought the nuts were undoing, then it started turning the bolt. I can't tell how the bolt is attached though, as you cant get to the head due to the rubber, you can definitely hear it turning against the rubber. I don't want to jump in and cut the rubber/nut though in case I can't get a replacement. It's proving quite a pain!

Oli

[droopsnoot]

See them on eBay from time to time, but I don't know of anyone doing them new.

[pbottomley]

Martin Robey, the Jensen specialist sell them if I remember rightly:

page 4

http://www.martinrobey.com/filestore/jensen.pdf

[1256man]

hello when this happened to me i tightened the nut down again cleaned the thread and lubricated and if you loosen and the n tighten again bit by bit it should come free also it helps if you jack the body up as well to tension the bolt so the bolts head is as tight in the mounting as it can be if that doesnt work use a nut splitter they are cheap enough to buy and save a lot of work

[oli8925]

That's great! Thanks. Will try getting them off next weekend.

Excuse my stupidity, but could someone point out the name and the part number on the Martin Robey site. I've found the part on the diagram but not in the list.

Thanks, Oli