by dann01 » Sat Dec 03, 2011 10:03 am
The ones without the lip for the bolt at the bottom are the front pair, and if they are the same as the pair I have, they are handed. If you look, you will see that the recess for the bumber is slightly deeper on one side than the other, this is because the front bumber is slightly angled towards the centre.
The deeper recess goes towards the centre of the bumper on both sides, so that the overiders sit square facing foward.
Positioning is entirely up to you, I found to fit them over the existing bumper fixing bolts placed them too far out, so pulled them towards centre about 8 inches. This lines them up with the sides of the air intake on the front valance and I think evens the car up. It also make the overiders level with the centre point on the bumper.
Dan
Sometimes, I wonder why I bother, and then for one fleeting moment things will go right for a change.