Page 1 of 2

Question #2 - side trim

PostPosted: Sun Jan 26, 2014 3:44 pm
by jpsmit
As in Question number one, I want to get the trim sorted before I replace the door glass. From the pictures you can see what I have - the body shop (before I got it) repainted with the existing clips in place - however, there are a few "posts" and a hole or two. I also have just one "clip." (last pic)

Image

Image

Image

How do I proceed? Are the clips available? How are they inserted? are they one piece or two? any opinions, answers or suggestions gratefully received!

cheers all
JP

Re: Question #2 - side trim

PostPosted: Sun Jan 26, 2014 3:45 pm
by jpsmit
Oh, and I presume the trim just "snaps" on? Is it from the top down, the bottom up or does it matter? and, how does it come off as I will be stripping a car before too very long. thanks!

Re: Question #2 - side trim

PostPosted: Sun Jan 26, 2014 6:41 pm
by bedfordbad
I believe they are the same as viva ha`s side clips,
Ive used these on my vans and they seem fine!!!
Not a very good photo on ebay though!!
http://www.ebay.co.uk/itm/Vauxhall-Viva ... 51b828e9f9

steve

Re: Question #2 - side trim

PostPosted: Mon Jan 27, 2014 12:55 am
by jpsmit
Steve, they do indeed seem the same - can anyone confirm this? Also, how do they install?

Re: Question #2 - side trim

PostPosted: Mon Jan 27, 2014 10:00 pm
by bedfordbad
You fit them by drilling a hole in the panel the same size as the largest round end and when fitted you lightly tap the other end with a hammer and it tightens in!!
steve..

Re: Question #2 - side trim

PostPosted: Tue Jan 28, 2014 5:53 pm
by logsplitterman
When you are tapping in the round pin through the clip on a large panel which is not braced you get a lot of bounce and the pin is difficult to send home. Get someone to hold a heavy lump hammer or something similar as near as possible to the drilled hole at the back of the panel, this makes the job much easier.
Regards,
Alan.

Re: Question #2 - side trim

PostPosted: Fri Jan 31, 2014 2:46 pm
by jpsmit
Thanks Alan, and is it safe to assume that I can just pop the old pins out from the back?

Re: Question #2 - side trim

PostPosted: Fri Jan 31, 2014 5:47 pm
by logsplitterman
Yes the old clip pins can be punched out from behind the panel and if still intact, used again. Good luck.
Regards,
Alan.

Re: Question #2 - side trim

PostPosted: Sun Feb 02, 2014 12:53 am
by jpsmit
Update: I contacted the seller and he says the HA clips do not fit but Triumph Dolomite clips do. I have ordered a set and will keep you posted. My only concern is that the Vauxhall will reject the 'umph parts and spit the trim off at speed! :D

here's hoping!

Re: Question #2 - side trim

PostPosted: Sun Feb 02, 2014 3:14 pm
by Bob perry
I picked up a bag of clips that fit, from an Autojumble somewhere, can't remember when, but they were in a Chrysler/Talbot bag, so I assume they were Avenger or possibly Imp or something!
Worth a try down that line.