Nose cone had 2 coats of spray putty then 3 coats of white hi build primer then 2 coats grey hi build primer,
New old stock front bumper blade , this will have plenty of wax squirted into the steel tubing
Wet flatted with p280 then p400 then p600.
cut out some headlight covers out of 4mm clear perspex , made sure to cut smaller than the opening cos the edges to be finished in rubber.
Used this product to edge the perspex , they are meant for door edge protection but fit the 4mm perspex perfectly , 2 boxes needed to do the 2 perspex units , with a bit spare just in case you cut the mitres in the corners badly
Both perspex units in place - next step is to make the retaining clips!
Saved this crappy steel table ? from a skip , the curve on the edges match the curve of the rubber strips - so this will be used to make the retaining clips