Page 1 of 2
Exhaust
Posted:
Sun Sep 01, 2019 1:47 pm
by Vauxste
Hi guys
Need your help. Still in process of restoring 1970 HB. Can you still obtain the olive that goes between exhaust downpipe and exhaust manifold. If not are there any fixes you can do to make a gas tight fit between these parts. The engine is the 1159cc one. Have got a HC one but as you all know it's too big. Also need a brake master cylinder,if anyone can supply part No and point me in right direction would be very grateful.
Many Thanks
Steve Douglas.
Re: Exhaust
Posted:
Sun Sep 01, 2019 3:28 pm
by 1972nail
I have some original Vauxhall cast iron olives here. I'm not sure if they are specifically HB but if you give me the dimensions I can check.
Re: Exhaust
Posted:
Sun Sep 01, 2019 5:15 pm
by Vauxste
Thanks for that. Just measured and internal diameter is 3.5cms and external diameter is 5cms. Thinking out of the box had an idea of using woodfire fire box sealing rope. Might be a last resort if I cannot source one.Never heard of it used before but unless someone comes and says no might give it a try.
Re: Exhaust
Posted:
Sun Sep 01, 2019 7:13 pm
by Johnboy HB
Brake master cylinder, depends whether it's drum brake or disc front, the disc brake m, cylinder isn't readily available & tends to be on the pricey side, the drum brake m, cylinder is available brand new, marketed as a clutch master cylinder for the old style land rover & is only about a tenner on e-bay, got one on my estate for the last couple of years
Re: Exhaust
Posted:
Sun Sep 01, 2019 9:27 pm
by 1972nail
Vauxste wrote:Thanks for that. Just measured and internal diameter is 3.5cms and external diameter is 5cms. Thinking out of the box had an idea of using woodfire fire box sealing rope. Might be a last resort if I cannot source one.Never heard of it used before but unless someone comes and says no might give it a try.
I'll check the ones I have
Re: Exhaust
Posted:
Sun Sep 01, 2019 9:28 pm
by Vauxste
It is drum brakes so going on eBay now. Thanks for info John.
Re: Exhaust
Posted:
Mon Sep 02, 2019 9:09 am
by Johnboy HB
Just had a look on e-bay.
https://www.ebay.co.uk/itm/Land-Rover-S ... Swy3JcSz9i you only have to swap the pushrod for the viva one
Re: Exhaust
Posted:
Mon Sep 02, 2019 6:28 pm
by vx-mike
Hi, pm me your address and I will pop an "O" ring in the post for you.
Mike
Re: Exhaust
Posted:
Mon Sep 02, 2019 8:01 pm
by Vauxste
Regarding the master cylinder John,I ordered the same one you linked last night. That's my job for Saturday.
Many Thanks for help.
Re: Exhaust
Posted:
Mon Sep 02, 2019 9:06 pm
by 1972nail
Got these out today and measured them.
About 38mm inside
50 mm outside.