Page 1 of 1
Cylinder sleeve viva ha
Posted:
Thu Jul 02, 2020 8:48 amby Cavansbh
Hi I would like to know the dimensions of a 1965 viva ha cylinder sleeve if any one knows all the dimensions of the sleeve I would be very appreciative or if any one knows where I can get 4 new ones I would be happy
Thanks and have a good day
Re: Cylinder sleeve viva ha
Posted:
Thu Jul 02, 2020 4:03 pmby Bob perry
Not sure of the actual bore size, but I'm sure parts co-ordinator can help you with supply of new cylinders.
Need to know if they are Girling or Lockheed I think!!
Re: Cylinder sleeve viva ha
Posted:
Thu Jul 02, 2020 6:24 pmby droopsnoot
I was wondering whether the OP meant brake cylinders (in which case, master or wheel end) or engine cylinders.
Re: Cylinder sleeve viva ha
Posted:
Fri Jul 03, 2020 12:43 pmby Cavansbh
Hi just to make it clear I mean for the block
Re: Cylinder sleeve viva ha
Posted:
Fri Jul 03, 2020 3:36 pmby Bob perry
Ah!! subtle difference grasshopper!!
According to the manual the standard bore size of 1057 engine cylinders is 2.925ins, that could be US measurement!! or 74.3mm.
There are no actual sleeves in the block. If the bore is beyond 60 thou wear, an engine reconditioning company will be needed to supply and fit sleeves, if it is at all possible?
Could be expensive too, might be worth seeking another block in that case.
Again, our parts co Ordinator can help I'm sure!!