Page 2 of 2

Re: Cables

PostPosted: Fri Aug 02, 2019 10:51 am
by HC Fairley
MSD 561 clips into a bracket on the rear face of the speedo meaning a nut is only required on the gearbox end.

I would be interested in 0826/66 if you are selling it Mike ?

However if that is the one 68 Dave needs then I am happy to give him first dibs.

Re: Cables

PostPosted: Fri Aug 02, 2019 10:53 am
by 1972nail
The 826/66 should fit your Hatch. It's short and a 72 is a better length but the ends are correct for the 7dial angle drive and the OHC gearbox. It's ideal for a 1300 GLS.

Re: Cables

PostPosted: Fri Aug 02, 2019 12:21 pm
by droopsnoot
I can't remember quite what the issue was - I seem to recall that the smaller threaded end was too small for either the gearbox or the speedo / angle drive. I got all my speedo cables out and tried to pick the best one, and I'd have used this if I could make it fit. Unless I've bypassed it because it looked the same as another.

Now you've said that, I'll have to check again of course, fortunately I have spare bits so I don't have to get under the car. So maybe that won't be available after all, I'll update later. Failing that, Dave should have first call on it.

Re: Cables

PostPosted: Fri Aug 02, 2019 12:56 pm
by Fred Dukes
The Throttle cable you have Mike is for the later model - earlier models had a similar connection arrangement at both ends
Speedo cable usually clips in to the back of the speedo as MSD561 - 63 3/4" long - Viva 1256 1973 - 79
Not sure about the 0826/66 which seems to have a screw connection at both ends which I would associate with HB speedo or HC twin dial dash yet on your box it claim compre with MSD561 :?

Re: Cables

PostPosted: Fri Aug 02, 2019 2:52 pm
by HC Fairley
Mine was originally clip in, 1975 model year, however it broke.

Replacement came out of this car, also 1975 and it is screw on ends.

viewtopic.php?f=165&t=14735&p=53721&hilit=HOX+413N#p53721

Original had symbols on the fascia, replacement has words.

Re: Cables

PostPosted: Fri Aug 02, 2019 3:04 pm
by 1972nail
HC Fairley wrote:Mine was originally clip in, 1975 model year, however it broke.

Replacement came out of this car, also 1975 and it is screw on ends.

viewtopic.php?f=165&t=14735&p=53721&hilit=HOX+413N#p53721

Original had symbols on the fascia, replacement has words.


The one with words is a earlier dash. Changed to symbols for the 1975 model year.

Re: Cables

PostPosted: Fri Aug 02, 2019 3:10 pm
by HC Fairley
1972nail wrote: The one with words is a earlier dash. Changed to symbols for the 1975 model year.


Perhaps the Green Machine was a 1974 car that wasn't registered until 75

Re: Cables

PostPosted: Tue Aug 13, 2019 6:30 pm
by droopsnoot
1972nail wrote:The 826/66 should fit your Hatch. It's short and a 72 is a better length but the ends are correct for the 7dial angle drive and the OHC gearbox. It's ideal for a 1300 GLS.


I had a look at this today, and the speedo end of the cable is too small to fit around the angle drive. It will go straight onto the speedometer, but that has a smaller fitting with a coarser thread. That's probably why it's only listed for earlier Magnums, which don't have the angle drive as far as I can tell.

Re: Cables

PostPosted: Tue Aug 13, 2019 8:33 pm
by 1972nail
All 7 dial dashes have the angle drive, certainly the viva 2300 one, the 2 Magnum ones and the GLS one I relieved from various scrap yards years ago all had.

I must check my spare speedo cables again.