Aup, thought id post it on a new thread as it may interest some of the HB chaps that might miss it on my other build thread.
I decided that my build would have to have a bonnet pull inside the car, so decided to see what was available to fit to the n/s kick panel and long enough to reach the catch, after researching the good old net i came up with the landrover discovery, which according to people in the know was exactly the right length.
First problem was it was too long, so much for people in the know. so first off the bonnet catch was cut down and a cable nipple was found to locate in the hole which was drilled 8mm.
Cable is to be fitted under the wing rather than in the engine bay but where i have it mounted you can go either way.