Page 1 of 1

Electric Fan

PostPosted: Wed Jul 17, 2019 9:03 pm
by Mike Attew
Just wondering, today sitting in traffic in over 30 degrees heat water temperature kept creeping up. Has anybody fitted an electric fan to help? is it worth it?
If anybody has fitted one what make?

Re: Electric Fan

PostPosted: Wed Jul 17, 2019 11:58 pm
by 1972nail
I fitted one to my OHC engine. I looked at Kenlow ones but decided to fit a cheap eBay one. By my reckoning I could replace a broken cheap one several times over for the for the price of a Kenlow. So far it has lasted 5 years trouble free. I also fitted a thermostatic switch and relay. The total cost of it all was less then £30.

Re: Electric Fan

PostPosted: Thu Jul 18, 2019 8:17 am
by Mike Attew
I used to fit Kenlowe to my old 70's Range Rovers, they were always expensive and I did look at their Website. They no longer make them for the DIY'er. I also always fitted the adjustable thermostat.
I think I will do this , it can't hurt to have a bit of help and there seems more stopped traffic nowadays.

Re: Electric Fan

PostPosted: Thu Jul 18, 2019 9:44 am
by 1972nail
I also bought a cheap (under £15) infra red thermometer from Amazon and used it to set the switch on temperature instead of trusting the gauge on the dash.

I set mine to come on at around 92 deg C measured on the thermostat housing, to allow for a bit of overshoot while the fan starts to cool. The engine output continues to rise to near 100 deg for a while after the fan cuts in. Max running temp for a cast iron engine should be in the region of 105 deg C. Red on the gauge would be about 115 deg C.

To clarify, I don't have the standard fan fitted, just the electric one.

Don't forget that you need a 'pull' fan if you mount on the inside or engine side of the rad and a 'push' fan if mounted on the outside or grill side. Some of the cheap ones are non reversible.

Smaller ones draw about 12-15A whereas a larger one can draw as much as 20A. So you will need a suitably rated relay and fuse arrangement.

I had the car over at VBOA Sywell a few weeks ago, with quite a long stint on the M6 in almost stationary traffic. I noticed the temp rising quite a bit throughout the journey but it stayed within the gauge safe range. I just put it down to longer and hotter than usual driving conditions. On the way home it did the same, but this time I noticed that the fan wasn't cutting in.

At home I had look at the installation to check it over. Hmmm... the setting on the thermostat was up at max. I had the car out at a show a week or two earlier with the bonnet partially open. The thermostat knob is right beside the radiator in full view. I can only think that some idiot thought it funny to turn it up full. It will be re positioned when I get time.

Re: Electric Fan

PostPosted: Thu Jul 18, 2019 11:17 am
by Mike Attew
Thanks for the reply, I have a infra red temperature gauge for checking these things. Funny thing seagulls hate them being aimed at them, they sometimes attack. :D

I will fit a push and leave the viscous in place to start with, I have ordered a fan and thermostat kit. I will have a fiddle when I get them. In traffic yesterday my gauge was very near the H but soon went down when moving. Problem is in traffic sitting idling the fan is idling and no air flow through.

I find now at shows you need to be present, my poor Moggy got a scratch down the door from a buggy which went to the undercoat, some people have no respect.

Re: Electric Fan

PostPosted: Thu Jul 18, 2019 11:49 am
by 1972nail
Mike Attew wrote:I have a infra red temperature gauge for checking these things. Funny thing seagulls hate them being aimed at them, they sometimes attack. :D


Now that's something to experiment with when I have an idle moment. :wink:

Re: Electric Fan

PostPosted: Thu Jul 18, 2019 12:12 pm
by Mike Attew
1972nail wrote:
Mike Attew wrote:I have a infra red temperature gauge for checking these things. Funny thing seagulls hate them being aimed at them, they sometimes attack. :D


Now that's something to experiment with when I have an idle moment. :wink:


We used these to check the temperature of pipes in the chemical industry and there were some seagulls on the pipe, they went crazy and attacked me and my mate.

Re: Electric Fan

PostPosted: Sun Jul 21, 2019 11:34 pm
by Orrp01
My intentions are to fit at least one when I get to that stage and remove the mechanical fan, must have a gander at yours sometime David

Re: Electric Fan

PostPosted: Mon Jul 22, 2019 9:59 am
by droopsnoot
1972nail wrote:I fitted one to my OHC engine. I looked at Kenlow ones but decided to fit a cheap eBay one. By my reckoning I could replace a broken cheap one several times over for the for the price of a Kenlow. So far it has lasted 5 years trouble free.


I have had a similar conversation regarding the thermostat on my "modern" Audi, with the general forum consensus being "fit a genuine Audi 'stat". My argument is (a) Audi don't make thermostats themselves, so you're only getting someone else's part in an Audi box, and (b) Audi want the best part of £40 for a thermostat and O-ring, versus £6 from a motor factor. As I don't pay labour to swap it, just the hassle, I can do almost seven cheapo ones for the same cost, so I'm not going to swallow the extra just for a fancy box. Oh, and for fact-fans - the thermostat in my "modern" Audi is the QTH102, 88-degree stat, same as it is in the Firenza. Last time I swapped it I was going to use one of the several spares I have for that, but I chickened out at the last minute and bought a motor factor one.

1972nail wrote:At home I had look at the installation to check it over. Hmmm... the setting on the thermostat was up at max. I had the car out at a show a week or two earlier with the bonnet partially open. The thermostat knob is right beside the radiator in full view. I can only think that some idiot thought it funny to turn it up full. It will be re positioned when I get time.


That's a similar story to a DSG member who showed his HS Chevette somewhere, and noticed in the queue on the way out of the venue that it was getting hotter than usual, only to find that the Kenlowe adjuster had been turned up to the maximum. The adjuster is a bit visible on Kenlowe as I recall, is there a way to remove the black plastic dial from the switch easily, and keep it somewhere in the car? You still have it if you need to adjust it while out, but it's not so tempting.