Hi all, as you have probably gathered I've got to the point where I'm lining up some new wings and I could do with some advice and information. Firstly, I would be very grateful if some kind person could measure the distance on their car between the red dots in the picture.
As you can see,I need to make a section of front panel from sheet and need a reference measurement. This will also help me in aligning the wing.
Secondly,the step between the rear edge of the wing and the leading edge of the door. What is the ideal and should it even be there at all. On the drivers side the original wing also has a step but I don't know if that's correct or not. The mig shroud held up in the photo is 6mm,with the step between panels being about 2.5mm
I'm looking for some reassurance before I fire up the welder.
Many thanks, Dave.