Johnboy HB wrote:That's what the drivers side inner wing was like on my estate, repaired it with two repair sections, I'm thinking about replacing the hinge pins on mine with the roll pin type as they are easier to remove, just need to find out what will fit
lord13 wrote:That is some serious rot in them there inner wings, have you got replacements?
1972nail wrote:Johnboy HB wrote:That's what the drivers side inner wing was like on my estate, repaired it with two repair sections, I'm thinking about replacing the hinge pins on mine with the roll pin type as they are easier to remove, just need to find out what will fit
Drill the holes out to 8 mm and fit 8 mm ones. The original ones are about 17/64th if I remember, the same diameter as an OHV pushrod.
Johnboy HB wrote:Measured a hinge pin & it comes out at 9/32, or 7.14 mm in diameter, would there be enough ' give' in a 8 mm roll pin to replace directly without drilling ?
Johnboy HB wrote:Measured a hinge pin & it comes out at 9/32, or 7.14 mm in diameter, would there be enough ' give' in a 8 mm roll pin to replace directly without drilling ?
Users browsing this forum: No registered users and 2 guests