rubbers for bonnet area.

[WAYNECOLVILLE]

Rubbers for bonnet holder and side bonnet aligners etc. Who supplies these. cheers

[1972nail]

I believe that they are being re-manufactured at the minute, or at least being looked at for re-manufacture.

[droopsnoot]

I've been looking at doing the side ones, though haven't done much more. Is there someone else on the case David?

[1972nail]

It was you I was thinking of......

[droopsnoot]

Ah, OK. I've been messing with the heater control knobs mostly, but did start digging around in the boxes for a decent bonnet rubber to take a mould from.

On the plus side, this warm weather means that any experiment goes off really quickly, so I can do several "runs" in a normal afternoon without leaving things overnight to set.

[Mike Attew]

Hi Droopsnoot,
Is this what you are looking for?, not pristin but usable possibly to make a mould from? If so you are welcome to borrow it.

[droopsnoot]

Thanks, I've got one as good as that but have some other options to go with.

[lord13]

ahh I've just given a bag of these away , i had about 6 ...i may have some more somewhere, i'll have a look . . .