by OUL 735 L » Thu Apr 04, 2019 4:50 pm
Good Afternoon All
I have filter problems myself, same set up, brabham carbs on a 1256 HC.
The rear filter is the problem as it is fouled by the servo, you may be able to forced on but no gap to allow for engine rock,
I am thinking to move the filter up by cutting out the part of the filter and holes that attaches to the carb, then a cut and shut job to another filter backplate to lift the filter about an inch, hopefully not catching on bonnet when it is put on, will need a plate fabricating to mount the throttle cable, but not got that far yet. been putting all this off for ages trying to think of an easier way.
Wondering if a HB servo would sort the problem and look right
Regards
Ian