Hurrah i'm well happy the tool works really well, the top one moved quite easily without much effort on the spanner, however the lower one was very tight, so i just went for it if the tool broke it would be onto mk3 but sure enough up she came, brill.
What i wanted to do was make something that would pull out the pins as is, ie no heat or bashing and doing minimal damage, the first 8mm or so is tight but it then gets easy, the tool is really just to pull it the first 20mm or so which it does, after that its easy to tap out with a piece of bar with a slot in the end to fit over the pin head.
- photo 1 (20).JPG (48.54 KiB) Viewed 4518 times
- photo 2 (22).JPG (49.83 KiB) Viewed 4518 times
- photo 3 (15).JPG (46.12 KiB) Viewed 4518 times