Adjusting stromberg carb, late 1256 engine

[Johnboy HB]

IMG_20241127_175215.jpg (35.27 KiB) Viewed 104 times

I take it that this is where you adjust a stromberg from a late 1256, presumably, there's a special tool for this, my question is, how easy is it to knock up a tool to do the job? My thoughts are to cut a castle section in an old socket, or is there an easier way? Image taken off the net

[droopsnoot]

If it's the same as mine (and I think it is), I got a piece of flat steel and filed a drop in the top of it to clear the centre section. It's only the width of the section that turns, but it's enough leverage to turn it.

[Johnboy HB]

Thanks for that Mike, I did think after posting that I only need something with 2 flats in order to work