Page 1 of 1

Workshop manual

PostPosted: Sun Sep 22, 2019 5:52 pm
by Mike Attew
I have just acquired a Series HC workshop training manual, it used to belong to the local Technical College and the teacher who used it has just passed it onto me. The engine sizes in it are in cu inches , 70.7 and 97.5. [ 1158 and 1598 ] . At the end of the chapters there is a supplement for the HC and Firenza which covers bits of the 1256, 1975, 1759 and 2279 engines but not in the same detail with part dimensions. Will still be handy though.

Re: Workshop manual

PostPosted: Sun Sep 22, 2019 6:04 pm
by Fred Dukes
Nice one Mike

Re: Workshop manual

PostPosted: Sun Sep 22, 2019 8:51 pm
by 1972nail
That's the one I have, mine was ex library. I also have a good set of the orange ones and the suppliments.

Re: Workshop manual

PostPosted: Mon Sep 23, 2019 8:26 am
by Mike Attew
1972nail wrote:That's the one I have, mine was ex library. I also have a good set of the orange ones and the suppliments.


Hi David, What do the orange ones and supplements cover?

Re: Workshop manual

PostPosted: Mon Sep 23, 2019 9:20 am
by droopsnoot
Much the same as yours, I think, but not bound together. I have quite a few of the orange ones, and they have similar TS numbers to what you have there. TS1024 is the body manual, TS1126 a supplement to it, TS1156 another one, and so on.

Re: Workshop manual

PostPosted: Mon Sep 23, 2019 5:40 pm
by 1972nail
Mike Attew wrote:
1972nail wrote:That's the one I have, mine was ex library. I also have a good set of the orange ones and the suppliments.


Hi David, What do the orange ones and supplements cover?


They contain exactly the same as the bound volume you have. However there is a specific orange Firenza manual that is not included in the bound volume.