Custom throttle linkage

[Jon-HPF]

Well thats cleared that up then - thanks Les , must say Paul the attention to detail in that engine / bay is impressive - you certainly have been busy .
Still think a stainless steel link would look great .
Cheers - Jon

[pbottomley]

Well thats cleared that up then - thanks Les , must say Paul the attention to detail in that engine / bay is impressive - you certainly have been busy .
Still think a stainless steel link would look great .
Cheers - Jon

Stainless / chrome will come along later as time goes on Jon... one has to get it going first Always work in progress

[House]

Nope, only proper metric stuff here.

[hbpeter]

Linkage in the process of being made. Bar will be stainless, thats the nearest stuff we had and even thats going to be turned down by our ever helpfull turner 1/4 is about 6mm. If the helpfull plater I persuaded(conned) to cut the plates hasent done them yet, I'll see if they can be stainless as well, might end up slightly thicker but that shouldnt make any difference. If you want a thread on one end, speak now.

Peter

[pbottomley]

No thread sir

[hbpeter]

Oky Doky

Peter

[viva les vegas]

1/4 is about 6mm

I was close

[hbpeter]

Parts are made, getting Tig welded in the morning, had a right carry on getting some stainless bar. The lathe idea didnt work. Got some now though. And dont ask why I had my hand down a 3ft deep sump beside the drill!!!!!

Peter

[pbottomley]

Let me know what your tipple is Peter and I shall add an extra crate to the pile

[hbpeter]

Linkage made, ready to post off.

Peter