Got it !!!!!! - hope its not catching!

[Jon-HPF]

update - all panel work and welding done , trial fit of lights and center reflector section , some further adjustments needed so they all line up when bolted in .

[Hosted_Picture][/Hosted_Picture]

[Hosted_Picture][/Hosted_Picture]

Final run now , just need to fill and get all the edges / bodywork right .

not sure about bumper - cos the lights are now almost flush under the lip of top panel , the bumper appears to sit too low below the lights and too far away from bodywork - so will have to mod the brackets to sort that out

[1972nail]

Looking good Jon.

[michaelmate]

Hi Jon , I know i said i wouldnt like it , but It looks Brilliant !!!

[dann01]

You been a busy boy... Looking good though.

Dan

[viva les vegas]

I like that. Looks like it'll be really good when you get the lenses in I've been considering an all LED rear, but I've got to focus on the front bits first, make it go.

[Jon-HPF]

Drivers side gutter now finished - in rattle can white

[Hosted_Picture][/Hosted_Picture]

[Hosted_Picture][/Hosted_Picture]

[Hosted_Picture][/Hosted_Picture]

[Hosted_Picture][/Hosted_Picture]

Welded up the cill plate holes / filled in - plan to use self adhesive rubber strip

[Hosted_Picture][/Hosted_Picture]

Filled in the grooves on the arches to match the flat profile of the rear arch spats .

[Hosted_Picture][/Hosted_Picture]

Had to do the front to match ! - IMO , i think its suits the flow of the arch into the snoot area , looks a lot more modern.
[Hosted_Picture][/Hosted_Picture]

Rear nearly finished - decided to fully blend in the lower valance to bumper bracket area - and fill in the side bumper recess area just under the back light wraparounds . Bumper needed a bit of fine fettling so as not to foul the bodywork , and had to "adjust" the brackets to get the bumper sitting just right.

[Hosted_Picture][/Hosted_Picture]

[1972nail]

Looking good Jon... Ready for Billing?

[Jon-HPF]

Looking good Jon... Ready for Billing?

Thanks David, Yes It will be ready for Billing but probably in its usual spray can white / grey primer livery

was hoping to get it all painted but due to work (redundancy) again!! funds will be too low . May stretch to a new carpet and poss better front seats though

Cheers

Jon

[Jon-HPF]

Lens in , everything lines up


[Hosted_Picture][/Hosted_Picture]

[Hosted_Picture][/Hosted_Picture]

[jpsmit]

Looks great - very "of the era" which is wonderful. So often mods don't suit the year of the car - but that could have been from the factory