Page 10 of 10

Re: Got it !!!!!! - hope its not catching!

PostPosted: Wed Sep 23, 2015 6:14 pm
by 1972nail
Those bonded in rear quarters look good Jon. What you doing with the openers? Can I have first dabs on them?

Re: Got it !!!!!! - hope its not catching!

PostPosted: Wed Sep 23, 2015 9:02 pm
by Jon-HPF
Thanks David,

ive binned them - no only joking :D , will probably keep them as spares cos i dont have a spare set of fixed windows , i know they are rare so no harm in holding onto them for a while - but sure , if i need to get rid of them i will contact you first.

Jon

Re: Got it !!!!!! - hope its not catching!

PostPosted: Wed Sep 23, 2015 11:22 pm
by 1972nail
I've got a pair fitted to my car but one of the catches is a bit weak.

Re: Got it !!!!!! - hope its not catching!

PostPosted: Thu Sep 24, 2015 7:52 pm
by Jon-HPF
try looking at the roll pins , had same problem , found the pin had slipped out of one side of it locating hinge, tapped it back in - all ok :D

Re: Got it !!!!!! - hope its not catching!

PostPosted: Fri Sep 25, 2015 12:12 am
by viva boy
Hi Jon
Just got round to reading this post and realised it was your car I was in ore of at billing.
I actually thought it was a prototype car as it was so different.
You have done an amazing job building it and I can't wait to bump into you at a show to have a chat.
Massive well done from me

Re: Got it !!!!!! - hope its not catching!

PostPosted: Fri Sep 25, 2015 10:35 am
by Jon-HPF
viva boy wrote:Hi Jon
Just got round to reading this post and realised it was your car I was in ore of at billing.
I actually thought it was a prototype car as it was so different.
You have done an amazing job building it and I can't wait to bump into you at a show to have a chat.
Massive well done from me


thanks for the comments , its nice to hear :D . though not to the purists tastes , its just my take on what it could have been if the low drag concept was taken a bit further .

Jon